Initial commit

pages/T7D.md

@@ -0,0 +1,73 @@
+T7D – Using basic test instruments: voltmeter, ammeter, and ohmmeter; Soldering 
+
+- [[T7D01]] (B)
+Which instrument would you use to measure electric potential? #card
+	- A. An ammeter
+	- B. A voltmeter
+	- C. A wavemeter
+	- D. An ohmmeter
+
+- [[T7D02]] (B)
+How is a voltmeter connected to a component to measure applied voltage? #card
+	- A. In series
+	- B. In parallel
+	- C. In quadrature
+	- D. In phase
+
+- [[T7D03]] (A)
+When configured to measure current, how is a multimeter connected to a component? #card
+	- A. In series
+	- B. In parallel
+	- C. In quadrature
+	- D. In phase
+
+- [[T7D04]] (D)
+Which instrument is used to measure electric current? #card
+	- A. An ohmmeter
+	- B. An electrometer
+	- C. A voltmeter
+	- D. An ammeter
+
+- [[T7D05]] Question Removed (section not renumbered) 
+
+- [[T7D06]] (C)
+Which of the following can damage a multimeter? #card
+	- A. Attempting to measure resistance using the voltage setting
+	- B. Failing to connect one of the probes to ground
+	- C. Attempting to measure voltage when using the resistance setting
+	- D. Not allowing it to warm up properly
+
+- [[T7D07]] (C)
+Which of the following measurements are made using a multimeter? #card
+	- A. Signal strength and noise
+	- B. Impedance and reactance
+	- C. Voltage and resistance
+	- D. All these choices are correct
+
+- [[T7D08]] (A)
+Which of the following types of solder should not be used for radio and electronic applications? #card
+	- A. Acid-core solder
+	- B. Lead-tin solder
+	- C. Rosin-core solder
+	- D. Tin-copper solder
+
+- [[T7D09]] (C)
+What is the characteristic appearance of a cold tin-lead solder joint? #card
+	- A. Dark black spots
+	- B. A bright or shiny surface
+	- C. A rough or lumpy surface
+	- D. Excessive solder
+
+- [[T7D10]] (A) 
+What reading indicates that an ohmmeter is connected across a large, discharged capacitor? #card
+	- A. Increasing resistance with time
+	- B. Decreasing resistance with time
+	- C. Steady full-scale reading
+	- D. Alternating between open and short circuit
+
+- [[T7D11]] (B)
+Which of the following precautions should be taken when measuring in-circuit resistance with an ohmmeter? #card
+	- A. Ensure that the applied voltages are correct
+	- B. Ensure that the circuit is not powered
+	- C. Ensure that the circuit is grounded
+	- D. Ensure that the circuit is operating at the correct frequency