Initial commit

pages/T7A.md

@@ -0,0 +1,78 @@
+T7A – Station equipment: receivers, transceivers, transmitter amplifiers, receive amplifiers, transverters; Basic radio circuit concepts and terminology: sensitivity, selectivity, mixers, oscillators, PTT, modulation 
+
+- [[T7A01]] (B)
+Which term describes the ability of a receiver to detect the presence of a signal? #card
+	- A. Linearity
+	- B. Sensitivity
+	- C. Selectivity
+	- D. Total Harmonic Distortion
+
+- [[T7A02]] (A)
+What is a transceiver? #card
+	- A. A device that combines a receiver and transmitter
+	- B. A device for matching feed line impedance to 50 ohms
+	- C. A device for automatically sending and decoding Morse code
+	- D. A device for converting receiver and transmitter frequencies to another band
+
+- [[T7A03]] (B)
+Which of the following is used to convert a signal from one frequency to another? #card
+	- A. Phase splitter
+	- B. Mixer
+	- C. Inverter
+	- D. Amplifier
+
+- [[T7A04]] (C)
+Which term describes the ability of a receiver to discriminate between multiple signals? #card
+	- A. Discrimination ratio
+	- B. Sensitivity
+	- C. Selectivity
+	- D. Harmonic distortion
+
+- [[T7A05]] (D)
+What is the name of a circuit that generates a signal at a specific frequency? #card
+	- A. Reactance modulator
+	- B. Phase modulator
+	- C. Low-pass filter
+	- D. Oscillator
+
+- [[T7A06]] (C)
+What device converts the RF input and output of a transceiver to another band? #card
+	- A. High-pass filter
+	- B. Low-pass filter
+	- C. Transverter
+	- D. Phase converter
+
+- [[T7A07]] (B)
+What is the function of a transceiver’s PTT input? #card
+	- A. Input for a key used to send CW
+	- B. Switches transceiver from receive to transmit when grounded
+	- C. Provides a transmit tuning tone when grounded
+	- D. Input for a preamplifier tuning tone
+
+- [[T7A08]] (C)
+Which of the following describes combining speech with an RF carrier signal? #card
+	- A. Impedance matching
+	- B. Oscillation
+	- C. Modulation
+	- D. Low-pass filtering
+
+- [[T7A09]] (B)
+What is the function of the SSB/CW-FM switch on a VHF power amplifier? #card
+	- A. Change the mode of the transmitted signal
+	- B. Set the amplifier for proper operation in the selected mode
+	- C. Change the frequency range of the amplifier to operate in the proper segment of the band
+	- D. Reduce the received signal noise 
+
+- [[T7A10]] (B)
+What device increases the transmitted output power from a transceiver? #card
+	- A. A voltage divider
+	- B. An RF power amplifier
+	- C. An impedance network
+	- D. All these choices are correct
+
+- [[T7A11]] (A)
+Where is an RF preamplifier installed? #card
+	- A. Between the antenna and receiver
+	- B. At the output of the transmitter power amplifier
+	- C. Between the transmitter and the antenna tuner
+	- D. At the output of the receiver audio amplifier