G2C – CW operating procedures and procedural signals; Q signals; full break-in

- [[G2C01]] (D)
Which of the following describes full break-in CW operation (QSK)? #card
	- A. Breaking stations send the Morse code prosign “BK”
	- B. Automatic keyers, instead of hand keys, are used to send Morse code
	- C. An operator must activate a manual send/receive switch before and after every transmission
	- D. Transmitting stations can receive between code characters and elements
- [[G2C02]] (A)
What should you do if a CW station sends “QRS?”
	- A. Send slower
	- B. Change frequency
	- C. Increase your power
	- D. Repeat everything twice
- [[G2C03]] (C)
What does it mean when a CW operator sends “KN” at the end of a transmission? #card
	- A. No US stations should call
	- B. Operating full break-in
	- C. Listening only for a specific station or stations
	- D. Closing station now
- [[G2C04]] (D)
What does the Q signal “QRL?” mean? #card
	- A. “Will you keep the frequency clear?”
	- B. “Are you operating full break-in?” or “Can you operate full break-in?”
	- C. “Are you listening only for a specific station?”
	- D. “Are you busy?” or “Is this frequency in use?”
- [[G2C05]] (B)
What is the best speed to use when answering a CQ in Morse code? #card
	- A. The fastest speed at which you are comfortable copying, but no slower than the CQ
	- B. The fastest speed at which you are comfortable copying, but no faster than the CQ
	- C. At the standard calling speed of 10 wpm
	- D. At the standard calling speed of 5 wpm
- [[G2C06]] (D)
What does the term “zero beat” mean in CW operation? #card
	- A. Matching the speed of the transmitting station
	- B. Operating split to avoid interference on frequency
	- C. Sending without error
	- D. Matching the transmit frequency to the frequency of a received signal
- [[G2C07]] (A)
When sending CW, what does a “C” mean when added to the RST report? #card
	- A. Chirpy or unstable signal
	- B. Report was read from an S meter rather than estimated
	- C. 100 percent copy
	- D. Key clicks
- [[G2C08]] (C)
What prosign is sent to indicate the end of a formal message when using CW? #card
	- A. SK
	- B. BK
	- C. AR
	- D. KN
- [[G2C09]] (C)
What does the Q signal “QSL” mean? #card
	- A. Send slower
	- B. We have already confirmed the contact
	- C. I have received and understood
	- D. We have worked before
- [[G2C10]] (D)
What does the Q signal “QRN” mean? #card
	- A. Send more slowly
	- B. Stop sending
	- C. Zero beat my signal
	- D. I am troubled by static
- [[G2C11]] (D)
What does the Q signal “QRV” mean? #card
	- A. You are sending too fast
	- B. There is interference on the frequency
	- C. I am quitting for the day
	- D. I am ready to receive